Ford remote start installation manual

• If the vehicle does not remote start, diagnose the concern. 5. Disconnect the vehicle battery negative terminal. For additional information, refer to Workshop Manual (WSM) Section 6. Disconnect the electrical connector from the back of the gateway module. INSTALLATION (Continued) Edge Vehicle Security/Remote Start/Remote. Lower the driver's door window, then close all doors, hood, and trunk/hatch and press lock on the keyfob. The LED should stay lit for 15 seconds while the VSS system pre-arms, after which it . Starting with the adjustment knob in approximately the halfway position, lower the driver's window and exit the vehicle. Press the LOCK button on .

Remote starters for manual transmission pose significant risks if not properly installed and operated. When testing to ensure the installation is working prop-erly, only remote start the vehicle in neutral gear, on a flat surface and with a functional, fully engaged parking brake. Do not allow anyone to stand in front of or behind the vehicle. Re: Remote Start Flex Install Manual. These are honestly pretty easy to install. The Bi-directionals are nice and the only grip I have heard is that they run the remote batteries a little quicker. The Ford units don't have a lot of the bells and whistles that some aftermarket stuff has but they are Solid. Remote Starter Ford SK5W7JAAA Installation And Technical Reference Manual All models (42 pages) Remote Starter Ford Vehicle Security and Remote Start Systems Owner's Manual.

Activate the remote start using the IDS. • Select the Tool Box icon. • Select Body. • Select Security. • Select Remote Start. • Verify that the information on the IDS screen is correct and all procedures have been followed. • Select Yes. This will enable the remote start function on the vehicle. INSTALLATION (Continued). Install the Remote Start Control Module and Harness Assembly Place the remote start module and harness assembly on the floor of the vehicle. Install the DNA-9 Relay Harness and Module Disconnect the Passive Anti-Theft System (PATS) transceiver electrical connector. • If the vehicle does not remote start, diagnose the concern. 5. Disconnect the vehicle battery negative terminal. For additional information, refer to Workshop Manual (WSM) Section 6. Disconnect the electrical connector from the back of the gateway module. INSTALLATION (Continued) Edge Vehicle Security/Remote Start/Remote.